APPX Software Library

Appendix A: Examples of Transaction Postings

Prepayment Processing

The processing of prepayments impacts two areas of Transaction Processing: Invoices and Cash Disbursements.

Invoices Entry

A prepayment is recorded by entering a “Prepayment” amount and a nonblank Purchase Order (PO) number. The PO number is used as the “Apply To” to record the prepayment. This number must be different from the invoice number to create a unique record of the prepayment invoice and payment that is separate from the remainder of the invoice. It also allows you to record the cash disbursement or “Hand Check” for the prepayment before receiving and recording the invoice.

Appendix A: Examples of Transaction Postings

Cash Disbursements

The payment of the prepayment amount can be recorded by entering a hand check (before or after the invoice is entered) or through system-generated checks (only after the invoice is recorded). If a hand check entry is made for a prepayment, the “Apply Type” entered should be “2” for “Prepayment,” and the PO number should be entered as the “Apply To.”

The end result invoice with the prepayment amount and PO number, and the cash disbursement with Apply To as the PO number is:

An unpaid invoices record for the prepayment that has a balance of zero.

An unpaid invoices record for the remainder of the invoice amount (Liability Amount - Prepayment Amount).

The General Ledger postings for a $1,000.00 purchase of office supplies with a $200.00 prepayment would be as follows:

Invoices Post

Cash Disbursements Post (for prepayment only)

THIS PAGE LEFT INTENTIONALLY BLANK.

APPX Software, Inc.

Accounts Payable User Manual

Published 5/95