APPX Software Library

Chapter 1: General Information

Option 24End Initial Setup

This function ends the Initial Setup phase of General Ledger. The following processing steps accomplish this job.

  1. Step 1NOTE: You will not be allowed to enter transactions in Live Operations until the Process Initial Setup function has run to completion without errors.

The screen shown below allows you to end the Initial Setup phase of operations.

End Initial Setup screen

The General Ledger End Initial Setup Screen
Figure 2

Data items for the preceding screen are described below:

End Phase?

Y or N Default Y Required

If you have selected this option in error, enter ā€˜N’ to return to the menu.

The entered data is validated. During validation, including access to other files, conditions may be found which cause messages to be displayed. Errors (E), Warnings (W), and Messages (M) that may result are shown below:

  • EProcess Initial Setup Must Be Run Before Ending Initial Setup

Press ENTER to save the information on this screen.

  1. Step 2This step ends the Initial Setup or Recovery Processing phases and begins (or returns to) the Live Operations phase.