Image Editor Toolbox Rules Option

The rules option from the Image Editor Toolbox presents an Events Point overlay with options to access the ILF Editor for applicable event points. If statements are defined in the event point, the event point option is highlighted. Refer to Chapter 3-16: Using Event Points for more information.

The Image Editor Toolbox Event Points overlay may contain some or all of the following options, depending on the type of process:

• start of process
• set run-time defaults
• post pcf read
• select image
• global ep's for images allowing access to four additional event points:
• start of frame
• global pre-display
• global option intercept
• end of frame
• pre-display
• pre-display/verify
• option intercept
• verify
• pre-pcf update
• post pcf update
• end of process
• file level ep's allowing access to five additional event points:
• file open
• post read
• pre-update
• post update
• file close

Upon completion of any event point, you are returned to the Event Points overlay. Press ENTER, select the close option, or select END from the titlebar to return to the Image Editor.