CDChartSetEdgeWidth < Main

---+ .CHART SET EDGE WIDTH

_This subroutine set the width of the 3D border for the "current" chart spec._

%TOC%
---++ Usage:
<pre>      PASS         &lt;chart_edge_width&gt;         FIELD            SHARE? N
      GOSUB    0CD .CHART SET EDGE WIDTH
      *        Check for error
      IF       0CD .CHART SET EDGE WIDTH      NE
</pre>
---++ Description:

This subroutine sets the width of the 3D border for the "current" chart spec. The *&lt;chart_edge_width&gt;* value specifies the width of the 3D border in pixels. This value only applies if the [[CDChartSetEdgeEffect][.CHART SET EDGE EFFECT]] subroutine has been called and the chart edge effect has been specified as "Raised" or "Depressed". If the chart edge effect has been specified as "Flat", then the *&lt;chart_edge_width&gt;* value is ignored. However, if the chart edge effect has not been specified and the *&lt;chart_edge_width&gt;* is specified, then the system will use the specified width to render a "Raised" 3D border around the chart.

The *&lt;chart_edge_width&gt;* parameter is optional. If specified, it must be an unsigned numeric integer value between 0 and 999. If the *&lt;chart_edge_width&gt;* parameter is not passed or if the value passed is blank, then any previously specified value for *&lt;chart_edge_width&gt;* is cleared and the default *&lt;chart_edge_width&gt;* as specified in the system parameter file is used.

---++ Comments:

_Read what other users have said about this page or add your own comments._

%COMMENT%

-- Main.SteveFrizzell - 2010-03-18

This topic: Main > WebHome > APPX510Features > CDChartDirectorDesignerAPI > CDChartDirectorBaseChartRoutines > CDChartSetEdgeWidth
Topic revision: r5 - 2012-02-19 - JeanNeron